Error-handling

Error list

This section shows a table of all of the possible error codes that can be returned by the scale. The error code is called 'RavasCode' in the .proto file.

Error	Req. action
`Ok`	None
`WEIGHT_NOT_STABILIZED`
`WEIGHT_OVERLOAD`
`TARE_WHILE_NEGATIVE`
`ZERO_OUT_OF_RANGE`
`CALIBRATION_OUT_OF_RANGE_NEGATIVE`
`CALIBRATION_OUT_OF_RANGE_SIGNAL_TOO_LOW`
`CALIBRATION_POINT_LOWER_THAN_PREVIOUS_POINT`
`CALIBRATION_POINT_NOT_VALID`
`COMMUNICATION_FAILURE_ADC`
`COMMUNICATION_FAILURE_IMU`
`MAXIMUM_FORK_ANGLE_EXCEEDED`
`ERROR_OIML_RESTRICTION`
`ERROR_NTEP_RESTRICTION`
`PARAMETER_CHANGE_NOT_ALLOWED_IN_LEGAL_FOR_TRADE_MODE`
`ERROR_ALIBI_FULL`
`LOW_BATTERY`
`WEIGHT_UNDERLOAD`
`UNKNOWN_ERROR`
`UNKNOWN_REQUEST_TYPE`
`PARAMETER_CHANGE_NOT_ALLOWED_READ_ONLY`
`UNKNOWN_PARAMETER_ID`
`INVALID_PARAMETER_TYPE`
`UNKNOWN_SCALE_NUMBER`
`UNKNOWN_PARAMETER_PAGE`
`INTERNAL_ERROR`
`INVALID_PAYLOAD_TYPE`
`COMMUNICATION_FAILURE_RTC`
`RTC_TIME_NOT_CONFIGURED`
`TOO_MANY_DIGITS_FOR_DISPLAY`
`CRC_ERROR`
`VALUE_OUT_OF_RANGE`
`WEIGH_IN_MOTION_NOT_COMPLETED`
`INVALID_PASSWORD`
`ERROR_LEGAL_FOR_TRADE_RESTRICTION`
`MORE_DATA`
`EVENT_LOG_FULL`
`TOTALIZING_ALREADY_FINALIZED`
`TOTALIZING_TOO_MUCH`
`TOTALIZING_MUST_RETURN_TO_ZERO`
`TOTALIZING_IS_ZERO`
`SYSTEM_WARM_UP_IN_PROGRESS`
`WEIGH_IN_MOTION_ZEROING_REQUIRED_OIML_R51`
`CALIBRATION_BUSY`
`USER_LEVEL_TOO_LOW`
`LOADCELL_SELFTEST_FAILED`
`NOT_IMPLEMENTED`
`NO_MORE_DATA`